#1 2018-02-13 10:32:16

Rick_Emslie
Member
Registered: 2003-12-22
Posts: 5

Victoria 30 - replacing injectors on a Yanmar 2GM20

We have a Victoria 30 and are about to embark upon the task of changing the injectors on our Yanmar 2GM20. Has anyone got any experience of doing this and, if so, can it be done readily with the engine in situ?

Many thanks

Rick Emslie

Offline

#2 2018-04-08 08:21:35

James_Van_Alstine
Member
Registered: 2014-06-18
Posts: 6

Re: Victoria 30 - replacing injectors on a Yanmar 2GM20

I had the injectors on our 2GM20 (V30) refurbished just over ten years ago. With Yanmar service manual I don't recall it being too difficult. Engine was in situ. Also had blown head gasket. So refurbished head at same time. Borrowed torque wrench to install properly.  I did take engine off mounts in 2016 to replace gearbox and a couple mounts. Surprisingly reasonable job using our oversized main sheet pulley system. Good luck!

Offline

#3 2018-04-10 08:59:42

Rick_Emslie
Member
Registered: 2003-12-22
Posts: 5

Re: Victoria 30 - replacing injectors on a Yanmar 2GM20

Many thanks, James. Most helpful and reassuring!

Offline

Board footer

Powered by FluxBB